Aztec Temple v2.1

thingiverse

### Update 22.07.2021 ### Due to the unexpected demand I have now invested a little more time and improved the design. Thanks for your comments. Changelog - 2.0 -> 2.1 - additional chamfers and filets for stability and wrapping - possibility to screw "Lower" and "Earth" parts together (M2, preferably DIN 4762 12mm) - pins reinforced - additional symbols on “Lower” part - the design is still scalable (except the screw) Tip: The "Upper" and "Lower" parts can be glued, positioned together right in the slicer or plugged. When plugging you have to take care that the hole size fits exactly (easiest is to use the "horizontal expansion" setting in the slicer). ______________________________________________ Hi everyone, I recently saw the "Aztec temple plant pot" print and thought it was a pretty good idea. But after looking at the parts I saw that there was not enough space inside and that the water couldn’t drain. So I hollowed out the parts, adjusted them a bit and added 2 areas for more earth and water. Also found a few DWGs of Aztec symbols and attached them. if you like this model then don't forget to like the OPs one.