Azeron Thumb Button Riser

thingiverse

This is to raise the thumb button on the Azeron Cyborg to closer to level with the thumb stick. I tried other versions on here, but the problem is the screw that the Azeron uses is NOT an M2 or M3. I don't know what it is. Because of this I couldn't find a longer screw of the same size to use the other one's that people made that simply use a longer screw to raise the thumb button. This will raise the thumb button by 15mm. This design allows you to use the original screw that came with the Azeron along with one or two M3 screws and normal M3 nuts. Simply insert the nuts into one end into the hexagonal holes. It may help to dab a TINY bit of super glue on the nuts to hold the nuts in place to make installation easier. Screw the riser onto the bottom of the button. Then select either the front, back, or both additional holes with M3 screws to mount the riser to the Azeron. You may have to use an exacto knife to widen the slot a bit at the top where the molding is squished over a bit in order to fit the M3 screw through.