Axle Stand for Filament Rolls with Guide Tube for FlashForge Finder

thingiverse

The FlashForge Finder has a significant flaw: Its internal filament compartment is sized only to hold very specific filament rolls. This design is a solution to that, containing both an axle to hold your filament on, and a guide that mates with the FlashForge Finder's rubber tube. The axle can be supported either by a tower that stands on your desk, or by a clip that mates to the front of the printer. Note that the tower and clip cannot be used at the same time; this will cause the bottom of the tower to dangle in midair instead of resting on your desk! This design uses the Mark of Making from Keith Baker's Eberron. I do not own this symbol or any associated IP.