Axial SCX6 - LED Light Pod Kit

prusaprinters

<p>A very close to scale SCX6 light pod kit. You'll need the following to make this kit work:</p><p>4 x 3mm LEDs<br>4 x M2 10mm socket head bolts (8mm through 14mm are also ok)<br>1 x M3 20mm (for holding the pod to the mount)<br>1 x M3 18mm (or longer) for securing the mount to your truck<br>1 x M3 nut (for mounting the light)<br>1 x M3 locknut (for keeping the pod mount tight)</p><p>Wiring is sort of up to you; I used a servo extender and just cut off one side. You'll want to wire the LEDs in two series sets and then each of those series sets gets wired together. At 6v you'll be good to go; otherwise you'll need a resistor.</p><p><strong>Notes:</strong></p><p>Print as provided; you'll need supports for the case and mounts. Using "from base" for supports should work just fine.</p>