Axial SCX24 JK Style Beadlock Wheels

thingiverse

I did another remix of kman250's great Method V2 wheel design for the Axial SCX24 to make them into a JK Style Wheel. For some reason I couldn't figure out, the beadlock ring will only line up in one orientation so take care when lining the holes up. At the time of posting these files, I am unable to test tyre fitment because I don't have any spares and anyone with an SCX24 knows they're more than slightly hard to get hold of unfortunately. Now I know the wheel is absolutely fine, but I'm not sure about the beadlock ring. Not having any tyres to test it with, I don't know if I left enough gap for the bead. I would suggest printing one ring to test and if it's too tight to mount, reduce the width of the ring in your slicer to get the right gap. Printing wise on the wheel itself, I just used support, no brim or raft. I used 0.2 layer height, but personally for a final print, I'd go finer than that to get a better result. The beadlock ring suggests either a brim or raft and support because there is very little area actually on the bed. The wheels mount with 5 x M2 x 6mm screws per wheel. Update: I've now added a Vented set of wheels, basically got a 2.5mm hole in each wheel and ring, and a recessed channel on both. Also, it's bang in the middle of the wheel so doesn't matter which way round the ring goes on.