Awesome Moving Wings

thingiverse

Awesome Flying Wings Cool wings that move while moving your hands There are 9 three-dimensionally printed parts and four foam board wings. Print Settings Printer Brand: RepRap Printer Model: Delta Rafts: No Supports: No Resolution: 0.2mm Infill: 10% Assembly Instructions BOM: 1 foam board sheet (100X70 cm) Hot glue gun + tubes Four meters of pant rubber (2-2.5 cm width) Two non-woven fabric sheets (110X180 cm) Nine three-dimensionally printed parts (detailed below) Four meters of 4mm paracord (550 yards) Printing the Parts Print: Four Top Buckles Four Top Buckle Pins One Center Buckle Cutting the Wings Draw two of each wing design on the foam board sheet, ensuring enough space for all four wings. Cut the wings using a utility knife, being careful not to cut yourself. Cutting the Feathers Draw as many feathers as possible on the non-woven fabric sheets. Glue the feathers onto the wings using hot glue. Connecting the Printed Parts Insert a Top Buckle Pin into each hole of the wing that is not at the tip. Apply hot glue to the tip of the pin and insert it into the hole of the Top Buckle. Note: Before gluing, ensure that the pin fits the hole. If not, enlarge the hole. Inserting the Wings onto the Straps Cut three straps of rubber that fit around your body. Attach the Center buckle to the first strap. Attach the two small wings to the second strap, ensuring they are in the correct direction. Attach the two large wings to the third strap, ensuring they are in the correct direction. Tying the Straps Tie the first strap around your waist, with the Center buckle at the middle of your back. Tie the third strap under your armpit, so that the Top Buckles are on the edge of your back. Tie the second strap between the first and third straps, so that the Top Buckles are on the edge of your back. Connecting the Paracord - Big Wings Have a helper assist you with this step. Tie one end of the cord to the hole at the edge of one of the upper wings. Pass the rope through the Center buckle and hold it in place with your hand. Repeat this process with the other upper wing, using a different piece of cord. Connecting the Paracord - Small Wings Hold the upper wings in an open position (with your hands up). Attach another piece of cord to the hole at the edge of one of the smaller wings. Pull the cord to the desired position while it's open and tie it to the cord of the big wing on the same side, just above the Center buckle. Repeat this process with the last wing, using a different piece of cord. Done!