Automatisation d'une antenne MP1 (super antenna)

thingiverse

Automation of a super antenna using an Arduino Uno, a 28BYJ-48 motor + driver, and an infrared remote control... =================================================================== The code (test): Antenna movement with potentiometer (1K) in front (signalization via two LEDs - green and yellow) Waiting mode (red LED in front) Automatic recording of antenna position in EEPROM after each motor movement and a few seconds wait Possibility to store a position (via remote control) using 3 memories available Recall of a stored position using the remote control Display of information on LCD screen =================================================================== Required components: 1 threaded rod M3 (20 ~ 30 cm) 1 Spacer M3 1 Motor driver - threaded rod coupling (an old domino worked great!) 1 Potentiometer 1Kohm 1 28BYJ-48 motor + driver (pins 9, 11, 10, 6 of Arduino Uno) 1 Infrared remote control + receiver (pin 2 of Arduino Uno) 3 Color LEDs (+500 Ohm resistor) connected to pins 13, 12, 8 1 Arduino Uno 1 LCD screen 2x16 with I2C module Happy tinkering!