automatic dispenser

cults3d

I tweaked my initial toilet paper dispenser design to make the elastic band entirely invisible and significantly improve the recall of the movable legs. In addition, I've supplied two new models, one for rolls up to 12 cm in diameter and another for rolls up to 14 cm in diameter. I've also provided a test so you can fine-tune your printer and check the functioning of the joint. This process typically takes about 45 minutes to complete and requires approximately three meters of wire. For this design, I'm utilizing a two-inch diameter rubber strap that's double-braced for added recall stability. The entire part can be printed in anywhere from four to five hours, depending on your printer settings and model, with an estimated 18 to 20 meters of filament required. Update: On March 10, 2020, I added a version featuring hidden screws. To ensure the unwinder stays securely attached when removing the roll, gently force it onto the screws. When screwing in the wall attachments, maintain a center distance of 140.2 mm and leave minimal play. You can find all versions and updates by visiting this link: https://cults3d.com/en/3d-model/home/derouleur-papier