Autobots Matrix of Leadership

prusaprinters

<p>I purchased some Solmore RGB Cabinet Lights (Model NO.:S-CL-003) and remixed the insides of the original matrix (<br/> <a href="https://www.thingiverse.com/thing:326614">https://www.thingiverse.com/thing:326614</a><br/> ) to fit. Tolerances are tight so glue may not be needed.</p> <p><strong>NOTE: You must have an IR remote (included in light pack) for this build to work.</strong></p> <p>Disassemble the Solmore light and retain the screws holding the front cover to the battery pack.</p> <p>1) Gently press the LED and battery pack into the Crystal. This is a tight fit. The ridge on the battery pack will prevent the LED from going in too far.<br/> 2) Press the Crystal into the Front Ball.<br/> 3) Press the Back Ball onto the Front Ball, align so that the flat sides allow for a tight seal.<br/> 4) Insert the Arms into the grooves formed on top and bottom of the the constructed ball. Glue may be necessary to hold these in place.<br/> 5) Insert the Screws from the original housing into the holes on the back ball and tighten into place. Be careful not to strip the holes.</p>