Auto Bed-Leveling Z-probe for Makerfarm Prusa i3 with E3Dv5 hotend

thingiverse

This revised Z-probe holder is suitable for Marlin's Auto Bed-Leveling system. Due to my E3Dv5 hotend installation, I lengthened the original part as it was too short. However, note that this design may not be the strongest option; if feasible, use the shorter version instead. For instructions on how to assemble and install the modified Z-probe holder, refer to the original guide: http://www.thingiverse.com/thing:167430. To attach the servo shoulder to the main arm, simply insert it into the designated hole. Position the "single-arm" actuator/accessory on the 'Slot side' of the arm and secure with m2.5 screws. Fasten your switch onto the arm's slot using the same screws and a small accessory screw. The holder is compatible with either Alex Borro's replacement x-carriage end or my parametric version.