Auto Bed Leveling Sensor Mount For Anet A8

thingiverse

This is a greatly enhanced mount for the bed leveling sensor specifically designed for the Anet A8. Printing has become straightforward, but setting it up without any prior knowledge can be quite challenging. ==================================================================== To set up Auto Bed Leveling effectively, follow these steps: Z-Offset Instructions: 1. Bring your 3D printer to a complete home position. 2. Execute the command M851 Z0 to reset the Z0 Offset. 3. Save settings with M500. 4. Activate parameters with M501. 5. Home the Z Axis using G28 Z. 6. Move the nozzle slowly towards the bed until it generates noticeable friction on a piece of paper. 7. Record the Z value displayed on your printer's screen (subtract 10 from this number, then subtract 0.50 from the result). 8. Bring the printer back to its home position with G28. 9. Set the Z Offset using M851 Z X.XX, where X.XX is the calculated offset value. 10. Save settings again with M500 and activate parameters once more with M501. Congratulations! You have now completed the setup for Auto Bed Leveling.