Australian Camper Rig 1/10 Trailer

thingiverse

This is a 1 /10 scale Australian type camping rig mounted on a hauler. You may print or not print the camp rig and print only the hauler. The front hitch is mounted by 3x M2X10 bolts and glued to frame front. The frame rear is mounted by 4x M2x10 bolts and preferable also glued. The Au gear 1 and gear 2 are glued together and glued to the hauler if you prefer. The front cage also glued to the hauler The front hitch has a 3mm hole so that you can use a 3mm ball link and a ball stud to your RC car hitch. Top end must be positioned and bolted to the wheel fairing the lower end on to the arm. Position and amount of shocks is up to you. In my design im using 2 WPL C-240-1 shocks per side. You can find also 60mm shocks and find position for mounting them. Wheels are held by M4 bolt driven through the stud and bush, You need to print two studs and two bushes to do a set. And you need 2 X M4X60 then later trim to your correct size after install the wheels and tires. This is designed to run with 1.9 wheels and tires suchas the Canyon Trails by traxxas that are standard on TRX4 rc trucks.