AUS Friendly Dry Spool Stackable Storage System

thingiverse

AUS Friendly Dry Spool Stackable Storage System Decor 6ltr Cake Container Lazy Susan bearing Nitto Electrical Tape (Extra sealing) Spool Holder and Spool nut fit most spools while the small spool nut is for Wanhao/Cacoon create spools. Holes for spool holder are 5mm, so the lazy susan bearing holes needed to be drilled out as the low profile screws from Makerstore are 5mm. Use whatever hardware you see fit. Assembly Drill bearing for 5mm screws Mount the holder to the bearing, making sure to use low profile screws or they will touch. Mark out the holes for the lazy susan bearing in the bottom of the cake container and drill. Put Nitto tape over the holes cut to allow the screws through, giving a better seal. Mount the holder in the cake container. Put nitto tape around the rim of the container. Mark and mount the exit hardware. I used http://www.thingiverse.com/thing:487789 Install the filament, feed it through the hole and put the lid on. It will be a very firm fit with the tape. Stack, use and profit. Print Settings Printer: Wanhao Di3 Rafts: Don't matter Supports: No Resolution: 0.2 Infill: 25% Notes: Spool nuts may need to be scaled in the x/y by 5% for a better fit.