Aurora Apex Corner (Inside) with Support

thingiverse

After several failed prints and numerous frustrating efforts to clean up the remnants from the original model, I finally realized it required very little support on my printer. I added supports around the edges, especially for the small angled clips that hold the lights in place, and a central column sized appropriately for a #8-32 hex nut. Machine screws were used to secure the corners together. The central column is crucial for constructing the icosahedron, allowing corners to be loosely placed before tightening securely after light panels block access to the inside. Combined with wire connectors, sockets, and the original apex cap, I was able to conceal the controller board within the complete icosahedron. Power cables fit neatly into notches between panels where connectors would normally go.