Aurora 100 remix for eachine tx02

thingiverse

I modified the original frame by incorporating a 30-degree ramp to accommodate the Eachine tx02 via zip tie. Tabs were added on one side to secure the battery with a rubber band. The rear section where the LED would be mounted was trimmed off. Two millimeter holes were drilled in the arms for M2 standoffs, allowing for landing gear installation. A critical failure occurred when I crashed with the initial design, causing an arm to break. To address this issue, I filled the damaged areas solid - the weight difference was minimal, only a couple of tenths of a gram. It's possible that the breakage could have been avoided if I had employed better print settings. I'm grateful for Madizmo's excellent base design, which served as an ideal starting point for my modifications.