Audio Switcher Magnetic Wall Mount

prusaprinters

<p>I had recently purchased an 1/8" jack stereo jack switcher to link between two audio sources and some ceiling speakers. The switcher came with small rubber feet to allow it to sit on a desk. I wanted to hook it to a steel fileing cabinet. This was my solution.</p><p>The unit I picked up came from Amazon:</p><p>https://www.amazon.com/SOLUPEAK-M1-switcher-selector-Independent/dp/B093FT2PT5/ref=asc_df_B093FT2PT5/?tag=hyprod-20&amp;linkCode=df0&amp;hvadid=533458184851&amp;hvpos=&amp;hvnetw=g&amp;hvrand=18125530601116221790&amp;hvpone=&amp;hvptwo=&amp;hvqmt=&amp;hvdev=c&amp;hvdvcmdl=&amp;hvlocint=&amp;hvlocphy=9014904&amp;hvtargid=pla-1365781425795&amp;psc=1</p><p>Along with the unit above, you will also need 3/8" x 1/8" magnets (8mmx3mm). I picked these up at a local hobby store, but Amazon should have these as well</p><p><strong>How To Print:</strong></p><p>This print is in two parts (both identical). I printed mine in Inland Black PLA+ (from Microcenter). A pre-sliced file is included (with two sections) and a 3MF file has been deposited if you wish to slice your own.</p><p>After printing, you will need to install 3/8" x 1/16" magnets in the printed holes. These holes should allow you to press them in tight (no glue needed). Tha magnets sit slightly proud of the bottom to allow contact to any metal surface.</p><p>Remove the rubber feet from the switch unit, and clean off the surface-goop. The holdrs should just slide onto the each end of the switcher (If it is loose at all, add a little glue on the bottom side.</p><p><strong>About The Project:</strong></p><p>This was a simple design, using Autocad for the original design and Fusion 360 for truning into a 3D printable item. I have included the Fusion 360 file for study or modification.</p><p>Please enjoy and leave comments! </p><p><a href="https://paypal.me/Lockwatcher">https://paypal.me/Lockwatcher</a></p>