Audio Cable Clip

prusaprinters

<p>This is a small cable clip that can hold a standard 3.5 mm auxiliary cable, and help keep it tidy. It can be placed on a desk or can hang from the audio device depending on which end you loop twice through it.</p><p>&nbsp;</p><p>To use it, snap the cable through the single cable hole, close to where you want it to be. And the snap a loop of cable on the other side, you can then adjust it by using this loop. The “excess” loop can be tidied up with an additional clip if desired.</p><p>&nbsp;</p><p>I printed in PETG for a bit of flexibility, but it should also work fine in PLA, as the clip isn't under stress once the cable is in place.</p>