AU/NZ standard Electrical box - to house standard network and power faceplates

thingiverse

Electrical Box / Mounting Box to fit AU/NZ standard plugs, lights, network jacks etc. This was printed in 3cad, and can just fit onto my Monoprice Mini printer with a small 12cm square bed. You will likely want to add extra holes to it for cabling - this one snuggly fits a single power extension cord. (I used it to enclose a Shelly 1PM+ to measure and graph on/off times and voltage use of some appliances - the ugly black plug was all I had - and indeed I only built this because I did not want to travel 30kms round trip to my nearest hardware store/electrical supplier). This was designed in Freecad. The box is likely higher then it needs to be. It could also benefit from having slightly padded out edges (structurally its good as is, but its possibly 1-3 mm smaller then many fittings - a limitation of my 3d printer bed. It is "good enough" for me. I worked out if you get it right on the first print, its about half the price of buying a box (excluding getting to the store and back. Of-course, it took 4 hours to print).