ATX Power supply PSOn jumper

thingiverse

Jumper to connect green "PSon" and black ground wire, allowing ATX powersupply operation without mainboard. Proceed at your own risk; I assume no responsibility for damages to powersupply or related components. Print Settings: Printer Brand: Leapfrog Printer Model: Creatr Rafts: No Supports: No Notes: Sliced with slic3r using high quality settings, PLA filament at 190 degrees Celsius. Instructions: I used 1.3mm circuit board pins (12mm long) for this jumper. To solder a wire between two pins, insert the pins into an old ATX connector to achieve proper spacing during soldering. Use an old connector as excessive heat may damage it. Print the connector and pause just before reaching the "cap" section. Carefully push the two pins into the connector while maintaining contact with the printbed. Resume printing carefully.