ATX power supply holder Prusa I3 Hephestos

thingiverse

It bothered me that the ATX power supply was constantly lying around on my desk. Two existing threads were used on the left frame, and the design is still fully expandable. It's conceivable that the power supply would last until the end, eliminating the need for pinning wire. The power supply assembly must be positioned to avoid blowing up the printing table. A ribbon cable should be cut accordingly. The housing fits perfectly over my developed Ramps setup. Very high models with a 12cm height have a 5mm distance to the left margin, which isn't a limitation for me. In an intermediate step, I ensured that the motor x-axis and cage had at least 3mm clearance. Maybe I'll move the next draft slightly to the left. Printer: Prusa I3 Hephestos Rafts: No Supports: No Resolution: 0.3 Infill: 10-20% How I Designed This Fusion 360