ATLAS 3D Scanner by Murobo

thingiverse

These are the printable models for the ATLAS 3D turntable laser scanner by Murobo. ATLAS 3D is a successful Kickstarter project that brings a turntable 3D laser scanner based on the Raspberry Pi to the public. It runs the open source FreeLSS http://www.freelss.org laser scanning software available on Github https://github.com/hairu/freelss/. The following models are required to build ATLAS 3D: camera_arm.stl, qty 1; camera_bracket.stl, qty 1; camera_case_back.stl, qty 1; camera_case_front.stl, qty 1; camera_shaft.stl, qty 1; frame_connector.stl, qty 6; frame_section_2.stl, qty 4; left_laser_arm.stl, qty 1; right_laser_arm.stl, qty 1; left_frame_section 3.stl, qty 1; right_frame_section 3.stl, qty 1; left_laser_holder.stl, qty 1; right_laser_holder.stl, qty 1; rpi_cable_carrier.stl, qty 4; crossbar.stl, qty 5; camera_tower.stl, qty 1; camera_tower_front_plate.stl, qty 1; table_coupler.stl, qty 1; calibration_item.stl or checkerboard_calibration_item.stl, qty 1. The calibrationPattern.pdf file needs to be printed and glued onto the checkerboard_calibration_item.stl model if you want to use the checkerboard auto-calibration. Raspberry Pi 2 and Raspberry Pi 1 Model B+ users need to print the below two models: rpi_case_bplus_lower.stl, rpi_case_bplus_upper.stl. Only one of the following turntables needs to be printed: turn_table_d4.stl, 4" turntable; turn_table_d5p5.stl, 5.5" turntable; turn_table_d7p5.stl, 7.5" turntable. The following models are either optional or alternative models: camera_bracket_no_support.stl, left_camera_tower.stl, right_camera_tower.stl. The following models are only for the acrylic version of the enclosure: left_laser_hinge.stl, left_laser_hinge_holder.stl, right_laser_hinge.stl, right_laser_hinge_holder.stl. Assembly Video: https://www.youtube.com/watch?v=awtLSCLJ3qs Printable Instructions: http://www.soliforum.com/topic/13217/atlas-3d-scanner-instructions/