AT_AT Imperial Walker

thingiverse

This design is an authentic Imperial Walker from the Star Wars universe, specifically designed for 3D printing. It measures 2ft in length and 2ft in height, taking approximately 160 hours to print. The original model was sourced from the internet, where it underwent significant optimization to ensure successful 3D printing. The AT_AT Imperial Walker is a copyrighted design by Disney Corporation, intended solely for personal use. Here are the print settings used: Printer: Hatchbox Alpha Rafts: Yes Supports: Yes Resolution: 0.2mm Infill: 20% Notably, the body pieces of this model were divided into four sections to minimize support material and facilitate a smoother printing process. Smaller parts, such as the guns, required additional rafts and supports for stability. Simplify 3D's suggested supports proved invaluable in achieving successful prints. Post-printing procedures involved sanding down several areas to ensure accurate assembly. The hip and knee joints needed special attention to allow smooth movement. After sanding, a coat of primer was applied followed by painting, bringing the model to its finished state.