Asus Zephyrus G14 stand

prusaprinters

<h3>Summary</h3> <p>A stand for laptop Asus Zephyrus G14 - print 2 of them.</p> <p>You can improve stability by adding two pieces of 4mm diameter rod through the holes. I used unthreaded aluminum, easy to cut (about 27.8 cm long).</p> <p>The large hole on top allows proper cooling (fan vents are just above this part).</p> <h3>Versions</h3> <ul> <li><strong>v7.1</strong>: as printed on pictures</li> <li><strong>v7.2</strong>: not tested. Please send feedback if you are happy/unhappy with these changes:<ul> <li>width of thin bridges from 2mm to 4mm</li> <li>height of foot part from 2mm to 3mm</li> <li>3 x 0.5mm high holes under the foot, that you can stick pieces of rubber to prevent slipping</li> </ul> </li> </ul> <h3>Print files</h3> <ul> <li>Below : v7.1 gcode for <em>Prusa MK3S</em></li> <li>In the <em>User print files</em> page:<ul> <li>v7.1 for <em>Prusa MK3S MMU2S single</em></li> <li>v7.2 for <em>Prusa MK3S</em> (not tested)</li> <li>v7.2 for <em>Prusa MK3S MMU2S single</em> (not tested)</li> </ul> </li> </ul> <h3>Print instructions</h3><p>Printed with:</p> <ul> <li>Prusa MK3S MMU2S printer (single mode)</li> <li>PLA red (Arianeplast eco)</li> <li>Print on flat surface (lateral one)</li> <li>0.2 mm quality / Prusament PLA default parameters except:<ul> <li>3 perimeters</li> <li>increased Z support distance to 0.2 mm</li> </ul> </li> <li>Supports under both bridges</li> </ul>