Asus MB169b+ portable USB LCD stand

thingiverse

Stand that will hold your portable USB properly in portrait and landscape modes. The case, convertible into a stand, requires some adjustment for proper setup due to its finicky design. The legs stretch out adequately at both the back and front, ensuring stability regardless of orientation. Standing at 3cm wide, this stand can be printed multiple times; even when in landscape mode, one might get away with printing just one, though I prefer using three to ensure stability, especially for portrait mode where four could be used. This design can be printed on the lowest settings (0.3mm height) without support structures, using 3 perimeters, 3 top layers, and 3 bottom layers, along with a moderate 15% infill rate. I believe that the strength of this stand primarily comes from its top/bottom and perimeter layers. The fit is snug, so it's advisable to observe your bezel; upon inspection, my model revealed slight geometry changes, possibly up to 0.5mm in scale. Consequently, there might be areas where the fit is too tight, but it works everywhere I envisioned. A parametric source file allows for easy adjustments and dimension tweaks. There are also several TILT variants featuring a top face slightly angled at different degrees.