Astrodyne TDI C14 Power Inlet for RatRig V-Core 3.1

prusaprinters

Fits the Astrodyne TDI 084S.01500.00 and 082S.01500.00 C14 power inlet.  This is a high quality power inlet for 120v 15amp max 3D printers.  It is normally a “snap in” power inlet and is held in place by metal tabs, but often the force of unplugging the power cable can pull it out of any holder.  This is a two piece holder where the front cover is bolted over the power inlet and holds it in place when plugging/unplugging it.This goes between the two upright rails in the rear of a V-Core 3.1.  I designed it to only attach to the outer most aluminum extrusion to give more air space around the power inlet and to prevent the power inlet from directly touching the aluminum extrusion to prevent heat transfer.  These power inlets should be kept below 40c ambient, and if your chamber gets above that, then having separation between the extrusion and this power inlet can be important.