Associated Spur 32P 64T (GT2 Slipper)

prusaprinters

<p>This is what a Team Associated GT2 32P 64T spur gear would look like if it existed.<br/> I ran a 56T (ASC7957) but needed a bigger one so i made one using Fusion 360.</p> <p><strong> This is HALF of it, print it twice and then use the 3 holes to screw some M3 in for alignment and glue both halves together using thin CA glue or something similar. Then remove the screws.</strong></p> <ul> <li>Tolerances should be pretty close but it's best to drill the center hole cleanly using a 5mm drill bit before use.</li> <li>DON'T use a brim, you will never be able to remove it cleanly from the teeth.</li> <li>If your slicer supports it, use a small negative "Initial Layer Horizontal Expansion" to compensate the "elephants foot" effect of the first layer getting squished. I use (-0.16mm).<br/> UPDATE : I've ran this spur for 6 hours total now, no sign of failure anywhere ! Looks like eSun PLA+ is great for gears !</li> </ul> <h3>Print instructions</h3><p>Category: R/C Vehicles</p>