Arturia Minilab Mk II desktop keyboard stand

thingiverse

My Minilab sits on my desk and ends up getting stuff dumped on top of it. I wanted to angle it to make the controls more accessible, and to be able to use the space underneath it, so I designed this stand. The design is quite slim and very slightly flexible with only 15% infill, but the resulting stand is plenty strong and stable enough. I printed an earlier version that was far more rigid, but it used far too much material and just looked too chunky. Print two of the uprights (they are symmetrical) and one crossbar. I didn't pay too much attention to the width, just made it sit within the rubber feet and avoiding any screws that protrude from the base. It sits slightly off-centre if it avoids the foot pedal input socket on the back – you could narrow the crossbar to make it properly centered. The hooks that fit over the front and back could be made a bit smaller without risking it slipping off, but they are fine as they are.