Artists Paint Mixer

thingiverse

<b>Print them Small and Many!</b> <hr/> Print recommends 10x (80mm square) For model makers or even less. for small sizes don't use the combined print (may not separate) Gcode has been included for a 5x sized print which is ideal for fine model makers (my printer uses a 0.4mm nozzle and 1.7 mm filament) <hr/> Artists paint mixer: Paint at outer edges should dry faster than inner. This will give you the ability to get textures correct. For water artists, there is plenty of area for dry mixing or setting some towers for "dirty mixing" Alright, it's not the best for water artists (but does hold spills if using tower interior) It's more for fine brush model makers where you want a lot of colors but not too much at any one time and you want your cans closed. ie. Fill all voids with desired colors Fill some towers with turps - use those for cleaning, use sharp inner edge of tower to remove excess and re-dip. Use outer shelf too do quick mixes. Printing the Lid: Should work fine if you use some infill. Note the lid just sits on top of your desk, reccommendation is to put some rubber seal around lid bottom to stop Turpentine evaporating.