Artist-D Basic - Biqu H2 Adapters

thingiverse

[WIP] Biqu H2 Adapter plates for the JGMaker Artist-D. Uses stock metal mounting plates for minimal printed parts. Pinout board plate has 3 holes to attach the pinout board in whichever configuration needed. The holes are sized to be threaded, but a heat set insert can be used instead to avoid stripping the part. Z-adjustment flange is printed separately to improve part strength. Heat set inserts or nuts can be used for fastening. Additional fasteners needed: 1x M3 jam nut or M3 insert for z-axis adjustment for right extruder 8x M4 nuts or inserts to mount to stock plates 2x 6mm M3 standoffs 2x 10mm M3 standoffs (optional) 3x 3mm dowel pins for alignment (optional) 2-4x M3 inserts for pinout board adapter If reusing the original stepper motor cabling, I had to swap the position of the wires to have the motors step properly. Check to make sure your steppers are properly wired or you may fry a stepper driver. For E0: swap positions 1 and 6 on the JST 2.0 connector (yellow and white wires in my case). For E1: swap positions 3 and 4 on the JST 2.0 connector (green and brown). Oddly enough, the pinout boards on E0 and E1 were not symmetric. Both the turbo fan and hotend fans had the red wire in position 1 (left-most). Fan mount & shroud will be published separately.