Artillery X1 enfriamiento de drivers con cooler stock

thingiverse

Remix de Airguide by Foliengriller. In the previous model, the key drivers X and Y were relegated to the side, outside of the area where the fan pushes air with the most force and the outlet is very high, wasting airflow that doesn't pass through the heat sinks. In this new model, the outlet is smaller and adjusted to the height of the heat sinks. Internal air guides have been added to redirect the air towards drivers X and Y. I've modified it in tinkercad, here's the link: https://www.tinkercad.com/things/7oQDq9NMKqQ Instructions: - Disassemble the cooler from the lid and reassemble so that it pushes air inward. - Print with supports with the model inverted. - Attach the cooler first with the two screws closest to the board, then attach the remaining ones holding the model in place. It's a good idea to place a silicone supplement that tightens the model against the printer roof and against the cooler. Check out the photos of the original model.