Artillery X1 enfriamiento de drivers con cooler stock

thingiverse

Remix of Airguide by Foliengriller. In the previous model, drivers X and Y were relegated to the sidelines, outside the area where the fan pushes air with the greatest force, and the outlet is very high, wasting airflow that doesn't pass through the heat sinks. In this new model, the outlet is smaller and adjusted to the height of the heat sinks. Internal air guides have been added to redirect the air towards drivers X and Y. I've modified it in tinkercad, here's the link: https://www.tinkercad.com/things/7oQDq9NMKqQ Instructions: - Disassemble the cooler from the lid and reassemble it so that it pushes air inward. - Print with supports with the model turned upside down. - First screw in the cooler with the two screws near the motherboard, then screw in the remaining ones holding the model. It's a good idea to put a supplement of foam tape that tightens the model against the printer roof and the cooler. Look at the photos of the original model.