Artillery Sidewinder X1 Palette 2 adapter

thingiverse

This is for the Mosaic Palette 2 (Pro) and Palette 2s (Pro) I printed this in PLA with the large diameter on build plate. To install: Gently pull out white guide tube from extruder pressure lever. Slide Palette 2 adapter into top slot on fan side of lever. Insert guide tube back into extruder pressure lever from top, pushing it all the way down until top of tube is even with flat surface of middle hole of adapter. The tube locks adapter in place. You may have to trim guide tube if it's a little long, so it doesn't rub on extruder gear or interfere with rubber grommet and Palette 2 tube. Now attach grommet if you haven't already. You'll probably have to sand or file part of adapter that slides into pressure lever for it to fit right. I was able to install without removing lever, just make sure holes line up before inserting small guide tube. To remove adapter, you will have to remove lever and push guide tube out. You can still print without using Palette 2 guide tube.