Artillery Sidewinder X1 LED light strip extrusion profile with/without diffuser

thingiverse

This is a remix of the Ender 3 LED profile to attach onto the Artillery Sidewinder X1 using T-Nuts. Includes a 0.4mm diffuser. You can install the LED strip with or without the diffuser. Length is 160mm so you need to print 2 of them to cover the whole length of the 320mm top extrusion. Install using 4 M3 x 6mm bolts and 4 M3 T-nuts. If you use anything longer than 6mm M3 bolts they will hit the extrusion in the back before they can tighten. So you need to use 6mm M3 bolts. Also the bolt opening is exactly 3mm and 3D printers will not make perfect 3mm holes so you may have to screw/unscrew the M3 bolt a couple of times before the M3 bolt goes in and out freely. OR you can just print everything at 101%. Needed: 4 M3 x 6mm bolts, 4 M3 T-nuts It can be printed without supports as is using PLA or PLA+ but make sure you have good bed adhesion cause it will be 160mm tall and only 16mm wide holding onto the bed. Having said that, I use blue tape on the bed and I have yet to have a failed print with my SWX1.