Artillery Sidewinder X1 Bed Cable Relief

thingiverse

I designed a solution for the bed wires that were flexing too much and breaking near their exit points from the base. I built upon Skinah's remix of a bed relief (3863626) to create a custom end for the bed. To provide a smooth transition, I threaded a 24" zip tie into the wiring loom, creating a rounded bend that also serves as a secure mounting point for both ends. Initially, I had to extend the wires slightly to make this modification work effectively. The Artillery printer's wire length is just sufficient to reach the bed when it's fully extended, but inserting the zip tie and adding 5-6" to the wire length resolved the kinking issue at the base exit point. The custom mounting system on the base was designed by me.