Artillery Genius LED Bracket

thingiverse

Hello, I created a holder for the Artillery Genius right here. This probably also fits the Sidwinder, but don't count on it. The bracket attaches to the back of the X axis. To do this, you'll need a T-nut nut - either printed or made from metal. You'll also need 2 M3 screws. An LED strip is then glued onto the bracket. All that's left to do is hook up power and you're good to go. I'm adding a switch to my setup so I can turn off the light when it's not in use. The holder prints fine without support. Just flip it in your slicer so one side rests flat on the print bed. Halting here.