Artillery Biqu H2 mount with BLtouch for Volcano or normal hotend

prusaprinters

<p>This is a new mount for the Biqu H2 on any Artillery Sidewinder or Genius that I designed and tested with <a href="https://www.youtube.com/c/SolarityTechnology">https://www.youtube.com/c/SolarityTechnology</a>. There are two versions, one for the normal hotend, the other for a volcano hotend, which came with the stock extruder. It incorporates a Bltouch mount, the cables go through the back. It does not loose any printable area. It also has extra mounting holes unter the PCB for the Motor for even more rigidness, but it isn't necassery, it requires longer screws (M3x20). This new design also doesn't require to remove the V roller nuts. You can easily adjust the Z position of the probe pin with the top hex screw, it should be about 2mm above the nozzle. There are also versions vor the Sidewinder X2 and Genius Pro, but not with the stock leveling sensor. If someone gives me the the measurements, I'd be happy to modify it to work with the ABL sensors from Artillery</p> <p>Fan ducts: any duct for the biqu h2 should work <a href="https://www.thingiverse.com/thing:5345621">https://www.thingiverse.com/thing:5345621</a> I use this one <a href="https://www.thingiverse.com/thing:5202213">https://www.thingiverse.com/thing:5202213</a></p> <p>Bltouch offset:</p> <p>x_offset:-2.5</p> <p>y_offset:30</p> <p>Some helpful Klipper config for the genius: (I was able to gain 6mm in X and 13mm in Y thanks to a 235x235 springsteel PEI sheet)</p> <p>[stepper_x]</p> <p>position_max: 226</p> <p>[stepper_y]</p> <p>position_max: 233</p> <p>[extruder]</p> <p>rotation_distance: 3.4334</p> <p>[bed_screws]</p> <p>screw1: 26,26</p> <p>screw1_name: front left</p> <p>screw2: 165,26</p> <p>screw2_name: front right</p> <p>screw3: 165,165</p> <p>screw3_name: back right</p> <p>screw4: 26,165</p> <p>screw4_name: back left</p> <p>[bltouch]</p> <p>x_offset:-2.5</p> <p>y_offset:30</p> <p>[bed_mesh]</p> <p>mesh_min: 10.5,40</p> <p>mesh_max: 217.5,220</p> <p>[screws_tilt_adjust]</p> <p>screw1: 42,12</p> <p>screw1_name: front left</p> <p>screw2: 182,12</p> <p>screw2_name: front right</p> <p>screw3: 182,152</p> <p>screw3_name: back right</p> <p>screw4: 42,152</p> <p>screw4_name: back left</p> <p>speed: 50.0</p> <p>screw_thread: CW-M5</p> Category: 3D Printer Extruders