Art Supply Box Inserts

thingiverse

A clever and cost-effective design for the Hobby Lobby Art Box (HL Art Case) insert, crafted to replace the pricey token organizer without breaking the bank at $35+. Some key points to note: * To fill the entire HL art case, you will need eight of the large box inserts and four of the small box inserts. Print only what you require as your collection grows. * The design is tailored to fit around the two horizontal dividers located at the bottom of the HL art case (see images). * I deliberately chose a horizontal card orientation so that instructions and dials can be stored in the top pull-down section. For now, I will not create a vertical version. My cards are sleeved with Dragon Shields (66mm x 93mm), which fit snugly within the grooves, leaving just enough room to move. However, I am unsure about the compatibility of other sleeves that are taller. I utilize Ultra Pro Dividers (68mm x 96mm x 1mm) and designed slots specifically for this brand. These dividers fit perfectly into their designated slots without any movement, yet they can be easily pulled out when needed. I cannot guarantee that other brands will yield the same results. During the design process, I did have to sand the sides of the smaller (middle) boxes due to a slight width discrepancy. Before designing the larger boxes and cutting off the smaller ones' width, I adjusted their dimensions. All inserts should now fit without any sanding required; however, I never reprinted the smaller boxes to confirm. If anyone decides to create or remix this design, it would be fantastic to see the outcome. Feel free to print, share, modify, or distribute this design as you see fit. If you could link back to the original or mention my name, that would be appreciated so others can view the starting point of your modifications. Additional information: * The HL Art Case itself can be found at Hobby Lobby for $49.99, but it frequently goes on sale for $24.99. * Cards: Matte Non-Glare Dragon Shields * Dividers: Ultra Pro color dividers (purchased and used before I had access to a 3D printer) * I applied spray adhesive and added this designer's concept to my dividers, which can be found at https://boardgamegeek.com/filepage/190779/d3-horizontal-vertical-dividers-collection-eng-esp * Token boxes are available at https://www.thingiverse.com/thing:3974590 * To keep the top flap from falling every time I open the case, I used four tiny magnets (available on Amazon)