Art Deco Toothbrush Holder w/ Hole for Cable

prusaprinters

<h3><strong>The “New” Art Deco Toothbrush Holder – featuring a contemporary style cable routing hole for your electric toothbrush!</strong></h3><p>by W.J.B. – March 4th, 2022.&nbsp;</p><blockquote><p><strong>A classy, printable art-deco styled bathroom holder – featuring space for an electric toothbrush (with the embedded hole for feeding a cable) as well as room for other toiletries; such as a comb, perfume, or toothpaste!</strong></p></blockquote><p>Designed for the toothbrush contest held by none other than that of the Prusa Printers website, comes a classy detail-oriented, art-deco styled toothbrush holder with space for toothpaste, a comb, and perhaps any other toiletry that fits – with my recommendation being that of fine cologne or perfume.&nbsp;With designs fit with both Roman &amp; Greek design, as well as fine arches typically used on 1930s radio sets across the world, this fine printable design is fit for any contemporary or classic decorated bathroom with a modern twist – the ability to fit and perhaps charge (if you are able to put your cord through, typically USB-C) your electric toothbrush.&nbsp;</p><p>To print, it is recommended that you print under these conditions, following below! I must also reference that it is recommended to clean this with soap and water every once in a while as various filaments are naturally porous and may pose a risk for bacteria growth if given long-term contact with water – a place where the bathroom may provide!&nbsp;</p><p>&nbsp;</p><ul><li><strong>Recommended Filament Type &amp; Color: </strong>Silk White or Marble, PLA&nbsp;</li><li><strong>Brim: </strong>Not required due to high surface area contact on build plate, but no harm done if used while printing the model!</li><li><strong>Supports? </strong>The model pictured was not printed with supports on a Prusa i3 MK3S+, but some light stringing due to overhang was experienced – you may want to put some small supports on the front, whereas typically the other sides that overhang over the top (on the left, right &amp; backside) do not require them.</li><li><strong>Orientation? </strong>It is recommended to print with the bottom facing the build plate!</li><li><strong>SLA? </strong>I do not personally own an SLA/Resin printer, but it should work and would likely turn out very nice when printed smoothly – if not too large for the volume of the printer!<br><br><br>&nbsp;<strong>Happy printing – and enjoy this fine decoration for any bathroom decor! A Fusion 360 archive file is available in the downloads incase you wish to make any adjustments to the actual model if necessary.&nbsp;</strong></li></ul><p><br>&nbsp;</p><p>&nbsp;</p>