Arstid Ikea Lampshade

thingiverse

41.8mm diameter of hole allows 40mm socket to pass through and then you tighten the fastener on the socket while screwing in your bulb through a 100mm hole at the top. I printed using my Cr10 with a 0.8mm nozzle, white PLA material at a 0.2mm layer height and 33% concentric infill setting in Cura. This print job requires approximately 240g of filament. No supports are needed, but keep an eye on layer height and overhangs created if not using 0.2mm layers. The brass colored top was made by cutting white PLA and triggering a filament change detection switch that replaced the white with copper hatchbox PLA material. I continued printing at approximately 196ish mm height. Solutech PLA "Real White" 1.75mm filament is used for this print job. Special thanks to Taylor Stein from the Fusion 360 Staff on YouTube for providing this helpful guide: https://www.youtube.com/watch?v=3PnKBSOulwo