Arrow gun

cults3d

Human hybrid pistol fires either standard bullets or arrows. The arrows are crafted from a 6 cm piece of straw with a glued tip attached to it. To assemble this gadget, you'll need 1 screw measuring about 3mm x 25/30 or two screws measuring 3mmx10/12. You should put 2 rubber bands on the trigger and 2 more on the launcher. Thoroughly sand both the launcher and the inside of the barrel for optimal performance. Adding extra rubber bands can increase power; I've tested up to 3 on the launcher successfully. If the trigger doesn't lock properly under load, tighten the rubber band(s) by winding them up or add another one. Although this is just a toy, never leave it within reach of unsupervised children. You'll need approximately 38 meters of filament and 6-9 hours of printing time depending on your printer and settings. Your printer's accuracy might require adjusting some parts' sizes by a few percent more or less.