Arrma Typhon XLX2 ESC Mount

thingiverse

XLX2 mount works with Arrma Typhon and stretched Arrma Typhon (I used Kraton chassis on mine), or any other Arrma 6s vehicle where the servo is not sitting in the chassis the long way (like the Talion), and does not use the upper chassis support brace. Instructions: First, install the XLX2 on the mount by using four 3x8mm ball head screws with a 1mm washer. To secure the mount to the chassis, glue some 3mm hex nuts (not nylon locknuts) in the hex slots on the base of the mount. You will need longer screws, perhaps 3x10mm flat head. If you are planning on using the stock body, the body mounts may need to be adjusted as the stock body will sit about 10-15mm higher (even with the esc fan cover off). I'm planning on using washers on the front and a longer screw to bring the front mount up. If I end up needing a new 3d printed rear mount, I'll add the STL file it here.