Arrma Typhon 6S-V5 Shock Guard

cults3d

Made a guard for the front shocks on my Arrma 6S V5 Typhon. You will need screws that are about 5mm longer to mount Note: you may need to drill out the pre-existing holes to accommodate the screw size. This print was done in 4 perimeters to allow for such and maintain strength. I have not put this part through the test on the vehicle at this point. The print is about a 35 minute print. Currently working on a rear shock guard to help reduce impact on the rear wing. 1-10-21 after a test run and a fortunate roll (LOL) the part did not hold up well so I am redesigning it and also printing it in Carbon fiber PLA to see where we stand. If it is a success I will post the updated design in the near future