ARRMA OUTCAST NOTORIOUS 6S TOWER TO TOWER BRACE

thingiverse

Mounts for Arrma Tower to Tower Chassis Brace, Fits Outcast and Notorious 6s. This Revised Version Proves Extremely Strong, Holding Towers from Forces in Both Directions. You Will Need: 1) M4x20 Socket Head Allen Screws 2) 4mm Lock Nuts 3) M3x6 Button Head Allen Screws 4) Traxxas XMaxx Center Shaft #TRA7755 5) 180-220 Grit Sandpaper 6) 2 Part Epoxy 7) Aluminum Tubing, Pipe Cutter, Hacksaw, Band Saw 8) Tape, Painters Tape Recommended Instructions: 1. Confirm the Fit Between Rod Ends and Mounts for Hole Alignment. Clean Up May Be Needed to Allow M4x20 Screw to Slide Through. 2. Install Front and Rear Braces onto Towers. Rear Brace Mount Should be Slid Down Until it Touches Wing Mount. Front Brace Mount Should be Slid Up in Tower Notches as Far as Possible. 3. Measure from End and Mark a Line at 19mm for Bore Depth of Brace Ends. 4. Sand the End of Shaft up to Marked Line with 180-220 Grit Sandpaper Until it Inserts Fully into Brace End Bore. 5. Wrap Tape Around One of Brace Ends, Mark a Line from Open Bore End Up to 19mm (Front Reference Line for Cutting Driveshaft). 6. Mount Both Shaft Ends into Their Mounts via M4x20 Screw, Taped One Will be Front Brace End (No Need for Nuts at This Point). 7. Slide Shaft into Rear Brace End Bore Until Fully Seated to Marked Line and Sanded Portion of Shaft. 8. Lay Shaft Down onto Front Tower, Note and Mark the Shaft to Be Cut to Clear Both Tower. Remove and Cut Shaft at That Mark, Reinstall in Same Orientation and Lay Shaft onto Front Brace End. Make Final Mark on Shaft at Mark Made on Tape for Front Brace End (Final Cut). 9. Again Measure and Mark a Line from End to 19mm, Sand the End of Shaft Until it Slides into Bore of Front Brace End. 10. Remove Brace Ends from Mounts, Mix 2 Part Epoxy and Coat Inside of Brace Ends and Shaft. Insert Shaft into Both Shaft Ends, Install Brace Immediately with M4x20 Screws. Let Dry for Recommended Time on Epoxy. I Have Had Great Luck with Carbon Fiber PLA, So Don't Be Afraid to Use Just PLA. Enjoy! Check Out My Other Arrma Parts.