Arrma Kraton/Outcast 4S - Wing Mount Support Brace

prusaprinters

I had a TPU wing on my Kraton 4S but the screws ended up pulling through the mounting holes. This piece connects the two screws to prevent against this happening again, while allowing me to still use the wing with the widened mount points.This is the wing I am using on my K4: https://www.thingiverse.com/thing:4152440The other thing is that if you've had screws rip out the mounting points on a wing, instead of printing an entirely new wing (or stacking up washers, which eventually tears through again) this will support the wing from the middle, and if the screws somehow tear through it again, just print a new support instead of an entirely new wing.Print with 100% infill and 4 walls.UpdateAfter 10-15 bash sessions including high jumps and bad landings, including high speed upside down dragging across both grass and concrete, I can say this thing holds up great. Haven't had a single thing happen to the wing with this center brace.