arms undead

thingiverse

I created a decoration for Halloween, with arms sprouting out of the ground attached to hangers. Two sizes were made: small ones for a fun decoration and large ones for a realistic one. The small arms measure 5.2 cm wide by 14.3 cm long by 7 mm thick, taking just 2 hours and 14 minutes to print. The supports that hold them up are thin - only 0.4 cm wide by 8.9 cm long by 4 mm thick - but still take 43 minutes to print for both of them. The large arms measure a substantial 8.1 cm wide by 22.3 cm long by 10 mm thick, requiring an impressive 6 hours and 16 minutes to print each one. The supports that hold them up are thicker too: 0.7 cm wide by 14 cm long by 5.3 mm thick. A square support was also created for the large arms, measuring 3.9 cm by 3.9 cm by 8.8 mm thick and taking just under two hours to print - 1 hour and 57 minutes. I hope you enjoy your Halloween decoration and happy birthday to everyone!