Armbrust Laser Halterung für Crossbow Cobra R9

thingiverse

Laser Mount for the Cobra R9 in 2 Variations - for Lasers with a Diameter of 15 mm / 19 mm. This mount is installed in place of the Picatinny Rail, as in Germany, no laser or lamp can be directly attached to a Picatinny Rail (or other rails). In the shown form, it is permissible, as it is not directly usable on "real guns". !!! Attention !!! This only applies to the 15mm Laser! As for how far this type of laser -19mm with integrated adjustment possibilities- is allowed or forbidden, I cannot say and recommend checking/ verifying this beforehand!!! Suitable for Lasers with a diameter of 15 mm such as the LASERFUCHS Laser Module Punkt Rot 1 mW LFD650-1-4.5(15x68) or 19 mm LaserPOINTER Installation left or right in place of the Picatinny Rail. The original screws can be used. Adjustment of the 15mm Laser occurs by shifting and pushing/pulling the mount with a spring under the rear screw. M4 x 14mm screws are required. No nuts are needed, as the threads are pre-cut in the lower part of the model. However, it may need to be cut off afterwards.