Armattan Rooster W2812 LED Holder

thingiverse

This holder is designed for installation at the rear of your quadcopter, with a low profile to keep it elevated off the ground. Unfortunately, due to antenna placement constraints, there's limited clearance available. As a result, when using standard foam landing pads, the holder will likely come into contact with the ground. To avoid this, I recommend using slightly thicker foam landing pads on the quadcopter arms. When printing this LED holder, aim for 40% support layers to achieve very thin supports in the LED board holding area, as illustrated in the attached printing images. By doing so, the LED board should snap into place perfectly (note that you may need to lightly sand the PCB board if it doesn't fit due to tolerance variations). Enjoy!