Armattan Rooster "THE FINAL" XT60 and VTX antenna sma mount

thingiverse

Okay Kids and Grown-Ups... This Is It! Print With 20% Infill On Your TPU. Things Looked Great On Paper, But As The Build Progressed, Some Issues Arised With My Other Designs. This One Uses A 10mm Plastic Washer On The Outside And The "Toothed" SMA Ring On The Inside. There's A Small "Nub" On The Bottom Of The VTX Hole. After Attaching The SMA And Aluminum Supports, Place It On The Bottom Plate And Screw It Down Tight. The Nub Compresses Against The Bottom Plate And The SMA Has Less Chance Of Rotating Due To Over-Tightening By Those Who Are A Bit Too Enthusiastic With Their Antenna Installation. You Can Use CA Glue As An Extra Measure To Hold The XT Connector In Place, But The TPU Seemed To Compress Pretty Well When All Bolted Together, So It May Not Be Necessary.