Armattan Rooster TBS unify Pro HV and FC mount.

thingiverse

TBS Unify pro HV mount with FC or 4in1 esc stack. Placing it in the stack gives a cleanest design of all the trial designs I thought up. Notes: Best printed in ABS or high temp filament due to VTX temps. 1. There is a small front to rear offset, TBS fits in one direction only. 2. Holes are 2.8mm in diameter. Run screws back and forth while threading. 3. Tabs on the corners may need a small bit of trimming for perfect fit or can be chopped off (not really necessary, but added). 4. The FC / 4in1 tower standoffs can be height adjusted easily in any cad program for individual needs - simple push/pull. This stl accounts for JST connectors on the bottom of my FC as well as rubber grommets on my setup. 5. Snug fit all around to keep VTX from shifting around. R-xsr / antenna mount almost finished, will upload in apx 2days.