Armattan Rooster Extended Top and Bottom Plates

thingiverse

I designed these 2 plates so I could continue using my favourite Armattan tank frame with modern components, including digital FPV. In version 1 (the one I'm currently flying), the Caddx Vista cable has little to no slack as I have it mounted in the back. Version 2, I moved the rear 20x20 mounts ahead by 2mm. The top plate, at 2mm is plenty stiff using the additional 2 standoffs in the middle. Because of the raised nutserts on the Rooster, you should shave 1 mm off the 15mm standoffs in the middle. There are 30x30 holes in the back but I'm not sure how many 30x30 boards would fit without removing the middle standoffs. My primary goal with this was to extend the plates for the 20x20 Vista. Some of the 90 degree joints may require a bit of filing to get super snug. This is a limitation of the cutting process. I have all my stuff cut @CNCMadness in Canada. I have added the V1 files as they may be better suited to standard flight controllers, for example if you plan on mounting the DJI in the front or just want to use analog.